Новини


Додому / Новини / Процес виробництва коробчастої коробки

Процес виробництва коробчастої коробки

2020-02-17 hqt

Кожна консервна банка виготовлена ​​із залізного матеріалу - друк - різання - штампування - складання - упаковка - поетапно.

(1) Iron material: Generally, after confirming the order, the most suitable iron material will be ordered according to the layout, including the type and size of the iron material. The iron material is usually stored directly in the printing plant. For the identification of the quality of the iron material, you can Generally, the method of visual inspection is to see if there are scratches on the surface, whether the texture is uniform, whether there are rust spots, etc. The thickness can be measured with a micrometer, and the hardness can be felt with a hand.

(2) Printing: Both the film and the typeset are ready for printing after being printed to the printing house. Usually, a template is provided for the printing house to follow the color. What should be paid attention to in the printing process is to see if the printing color palette keeps up with the template. Whether the positioning is accurate, whether there are stains, whether there are scars, and so on. The printers generally responsible for these problems can control it by themselves.

inted iron material is returned to the factory, the material can be cut and cut according to the cutting bed. The main thing to pay attention to when cutting the mattress is to see if the operator cuts according to the knife edge line, and whether the length is consistent and uniform. Whether the workers scratch each other when discharging, etc., the quality should be checked at the initial operating station.

(4) Stamping: It is the pressing of iron pieces on a punching machine. This is the most important task of a jar. Usually, a jar can be divided into many steps to complete. The general process of the two-piece can of Tiandi lid is as follows: Lid: open material-flashing-winding line. Bottom: open material-flashing-pre-rolling line-winding line.

Heaven and earth cover bottom buckle process (bottom seal) The process of the can, lid: opening material-flashing edge-winding line can body: opening material-pre-bending-cutting angle-forming-button bone-punch body (button bottom)-back cover. The bottom process is: the opening of the material is usually the biggest loss of the product during the stamping process. Pay attention to whether the work is standardized, whether the surface of the product is scratched, whether there are batches of seams, and whether the collar is fastened. The usual practice is to arrange the confirmation of the production of large samples before the production of large products, and to produce according to the confirmed large samples, which can reduce a lot of trouble.

(5) Упаковка: Після закінчення виробництва відділ упаковки відповідає за очищення та монтаж, укладання в поліетиленові пакети та упаковку. Ця частина є обробкою виробу. Чистка продукту дуже важлива. Тому перед тим, як упаковувати, необхідно виконати роботу з прибирання, а потім упакувати відповідно до способу упаковки. Вироби з багатьма стилями повинні відповідати номеру моделі та коробці. поставити. На що слід звернути увагу під час процесу пакування, це мінімізація надходження дефектної продукції в готовий продукт, а кількість упаковки повинна бути точною.

Топ